MSDS

IPMT INC.®
WORLD PEST CONTROL
MATERIAL SAFETY DATA SHEET.
Date prepared, July 19, 2005
Manufacturer: Prepared by: Telephone No.
IPMT INC.® Arthur Simpson Emergency telephone No.:
4224 Waialae Avenue, Suite 321 National Pesticide
Honolulu, Hawaii 96816 Telecommunication Network:
1-800-858-7378
Non-emergency No.:
EPA Registration Number, None required 1-808-721-0460 PST

SECTION I. HAZARDOUS INGREDIENTS
Active ingredient chemical name: None
Chemical family: Hot melt adhesive coating, thermoplastic resin
HMIS Rating: Health: 1
Flammability: 1
Reactivity: 0
Other: personal protection
This product contains no components subject to the reporting requirements of Section 313 of the Superfund Amendment and Reauthorization Act (SARA) of 1986.Products:
Model NO. Name EPA EST NO. Product Description
CLI0010 Doom Tube Mouse 080722-CHN-001 Enclosed rodent glue board
CLI0011 Doom Tube Rat 080722-CHN-001 Enclosed rodent glue board
CHM0025 Fly-By-Nite 079530-CHN-001 Insect trap
The above products are glue devices and NOT pesticides under U.S.A. – EPA Regulations. They are labeled with the appropriate EPA Establishment Number.

SECTION II. PHYSICAL DATA
This MATERIAL SAFETY DATA SHEET is prepared to comply with the U.S. Occupational Safety and Health Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace Hazardous Material Information System (WHMIS). Unlisted ingredients are not hazardous per OSHA standards and are not included on the WHMIS ingredient disclosure list.
APPEARANCE: solid WATER REACTIVITY: N/A
COLOR: Clear to yellow EVAPORATION RATE: N/A
ODOR: None / Peanut Butter VAPOR PRESSURE: N/A
SPECIFIC GRAVITY: N/A BOILING POINT: N/A
VAPOR DENSITY: N/A SOLUBILITY: Soluble in mineral spirits
MELTING POINT: N/A BULK DENSITY: 7.03 pounds /gallon

SECTION III. FIRE AND EXPLOSION DATAFLASH POINT: N/A
FLAMMABLE LIMIT: upper limit, N/A. lower limit, N/A.
AUTOIGNITION TEMPERATURE: N/A
EXTINGUISHING MEDIA: Water, foam, inert gas
SPECIAL FIREFIGHTING PROCEEDURES: None
UNUSUSAL FIRE OR EXPLOSION HAZARD: None
SOLUBILITY IN WATER: None

SECTION IV. REACTIVITY HAZARD DATA
STABILITY: Stable
CONDITIONS TO AVOID; None
POYMERIZATION: Will not occur
CONDITIONS TO AVOID: None
INCOMPATIBILITY (MATERIALS TO AVOID): None
HAZARDOUS DECOMPOSITION PRODUCTS: None

SECTION V. TOXICITY DATA
LD50, ORAL INGESTION: N/A DERMAL SENSITIZATION: N/A
LD50, DERMAL : N/A SKIN IRRITATION: N/A
LC50, INHALATION: N/A EYE IRRITATION: N/A

SECTION VI. HEALTH HAZARDS
PRIMARY ROUTE OF ENTRY: N/A
SIGNS AND SYMPTOMS OF EXPOSURE: N/A
EMERGENCY FIRST AID AND PROCEEDURES: EYES: Flush with cool water for at least 15 minutes. SKIN: Remove glue with mineral spirits, mineral oil or vegetable oil. Wash skin with soap and water. For contact with hot product, immediately immerse or flush with cold water to dissipate heat, and call physician. INHALATION: Remove person to fresh air, and contact a physician. INGESTION: Small ingested amounts are not expected to produce adverse effects. Call physician or emergency phone number immediately for instructions. HEALTH HAZARDS (ACUTE AND CHRONIC): None known at ambient temperatures. Inhalation of hot product vapors may cause irritation of the respiratory tract. NOTE TO PHYSICIAN: None.

SECTION VII. CONTROL AND PROTECTIVE MEASURES
RESPIRATOR TYPE: Not required. GLOVES: Recommended, not required
EYE PROTECTION: Not required VENTILATION: Not required
OTHER PROTECTIVE MEASURES: Not required.
NATIONAL FIRE PROTECTION ASSOCIATION (NFPA) RATINGS:
HEALTH: 0 (minimal)
FIRE: 0 (Will not burn)
REACTIVITY: 0 (Stable)
SPECIFIC HAZARD: None

HAZARDOUS MATERIAL INFORMATION (HMIS) RATINGS
HEALTH: 0 (Minimal)
FLAMMABILITY: 0 (Minimal)
REACTIVITY: 0 Minimal
PROTECTIVE EQUIPMENT: None

SECTION VIII. SPILL OR LEAK PROCEDURESSTEPS TO BE TAKEN IN THE EVENT MATERIAL IS RELEASED OR SPILLED: General clean-up. Remove glue by applying mineral spirits to area of spill, wash with warm water and detergent. If necessary, mix soil or sand with material.
WASTE DISPOSAL METHOD: Wastes resulting from use may be disposed of on-site or at an approved waste disposal facility. Dispose of wastes in accordance with all applicable Federal, State and Local regulations.

SECTION IX. SPECIAL PRECAUTIONS AND STORAGE DATA
STORAGE TEMPERATURE: Room temperature
AVERAGE SHELF LIFE: Stable
SPECIAL SENSITIVITY (HEAT, LIGHT MOISTURE): None
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Store in original Container in a cool dust free environment. Wash thoroughly with soap and water after handling.
VENTILATION: Local exhaust – No
MECHANICAL: General – No
EYE PROTECTION WITH HOT MATERIAL: wear face shield.
HAND PROTECTION: Wear thermal resistant gloves and arm protection when working with hot material.
WORK / HYGENIC PRACTICES: Provide readily accessible eyewash stations. Wash contaminated skin promptly. Remove from skin with vegetable or mineral oil.
CALIFORNIA ADDENDUM (PROPOSITION 65) SAFE DRINKING WATER AND TOXIC ENFORCEMENT ACT OF 1986.
The following specific warnings are hereby given relative to substances that the State of California has identified as carcinogens and/or reproductive hazards under Proposition 65: WARNING: None

SECTION X. SHIPPING DATA
DOT SHIPPING NAME: None DOT LABELS REQUIRED: None required
DOT HAZARD CLASSIFICATION: Non-hazardous, not D.O.T. regulated.
FREIGHT CLASSIFICATION: LTL Class 60
BILL OF LADING DESCRIPTION: Vermin Exterminators, NOI

WARRANTY:
The information provided in this Material Safety Data Sheet has been obtained from sources believed to be reliable. Integrated Pest Management Technologies, Inc., ( IPMT INC.® ) provides no warranties, either expressed or implied, and assumes no responsibility for the accuracy or completeness of the data contained herein. This information is offered for your consideration and investigation. The user is responsible to ensure that they have all current data relevant to their particular use.